Epson PowerLite 1220 Installation Handbook page 2

Epson PowerLite 1220 / 1260
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.
4. Loosen the two screws holding the lamp in place (you can't
remove them).
5. Hold the lamp as shown and pull it straight out.
6. Gently insert the new lamp. (If it doesn't fit easily, make sure it is
facing the right way.) Then tighten its screws.
7. Replace the lamp cover, then tighten its screw.
8. Reset the lamp timer as described in the next section.
INSTALLATION HANDBOOK
Loosen, but don't
remove these screws
Maintenance
note
Tighten the lamp cover
securely so you do not receive
a lamp cover error when you
turn the projector back on.
2