Clean The Drain Pump Filter - LG WD-10120FD Service Manual

ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER ASSEMBLY
Rotor
Bolt
HINGE
(FRICTION DAMPER ASSEMBLY)

Clean the drain pump filter

100
1
Open the lower cover cap (
by using coin.
(ROTOR ASSEMBLY)
(1)
(STATOR ASSEMBLY)
Damper
) Unplug the drain plug (
the water flows out,
At this time use a vessel
to prevent water flowing on the
floor. If the water does not flow any
more,turn the pump filter (
open to the left.
Remove the BACK COVER.
Unscrew the bolt to pull out the ROTOR ASSEMBLY.
Disconnect the wiring connector.
Unscrew 6 bolts from the STATOR.
Remove the BODY FRAME.
Note : Hook of connector (1) is on the backside
Pull out the HINGE, pressing its snap.
Do not use the pulled out HINGE again
It may be taken off during operation.
3 2
) , then
)
29
3
2
Take out any foreign material
from the pump filter (
cleaning, turn the pump filter (
clockwise and insert the
drain plug ( ) to the original
place. close the lower cover cap.
). After
)