To Install Locking Clip - Graco Child Restraint Owner's Manual

8.6 To Install Locking Clip

1. Tighten the buckled belt by pushing down hard on the child restraint and pulling hard on the
shoulder belt.
the belt without allowing it to slip.
3. Attach locking clip to lap and shoulder belts as shown .
4. Rebuckle belt. Check that lap belt does not move
procedure.
Remove locking clip when not using child restraint. Store
under it's tab on the rear of seat.
Test installation to see if child restraint is secure.
1 2" (1.25 cm)
through latch plate. Re-attach locking clip.
into vehicle seat cushion to help buckle vehicle seat belt. Test
repeat above steps until secure.
21