Attach Backguard Or Island Trim - KitchenAid 9760618 Installation Instructions Manual

36" (91.4 cm) classic commercial style dual fuel convection range for residential use only
Table of Contents

Advertisement

Available languages

Available languages

4-Wire Cable from Home Power Supply
IMPORTANT: Use the 4-wire cable from home power supply
where local codes do not permit connecting to a 3-wire system.
A
B
C
D
A. Cable from home power supply
B. Black wires
C. Red wires
D. 4-wire flexible cable from range
E. Junction box
1. Connect the 2 black wires (B) together using a UL listed wire
connector.
2. Connect the 2 red wires (C) together using a UL listed wire
connector.
3. Connect the 2 white wires (F) together using a UL listed wire
connector.
4. Connect the green (or bare) ground wire (H) from the range
cable to the green (or bare) ground wire (in the junction box)
using a UL listed wire connector.
5. Install junction box cover.
3-Wire Cable from Home Power Supply
IMPORTANT: Use the 3-wire cable from home power supply
where local codes permit a 3-wire connection.
A
B
C
D
E
F
A. Cable from home power supply
B. Junction box
C. Black wires
D. White wires
E. Green (or bare) ground wire
(from range)
1. Connect the 2 black wires (C) together using a UL listed wire
connector.
2. Connect the 2 white wires (D) and the green (or bare) ground
wire (E) (of the range cable) using a UL listed wire connector.
3. Connect the 2 red wires (G) together using a UL listed wire
connector.
4. Install junction box cover.
10
E
F
G
H
I
F. White wires
G. UL listed wire connectors
H. Green (or bare) ground wires
I. UL listed or CSA approved
conduit connector
G
H
I
F. 4-wire flexible cable from range
G. Red wires
H. UL listed wire connectors
I. UL listed or CSA approved
conduit connector

Attach Backguard or Island Trim

WARNING
Excessive Weight Hazard
Use two or more people to move and install range.
Failure to do so can result in back or other injury.
1. Using 2 or more people, move range close to cabinet
opening.
2. Remove cardboard or hardboard from under range. Move
range into its final location.
3. Attach the backguard or island trim as required for your
installation. See "Tools and Parts." Attachment screws are
included in the package containing literature.
Attaching the Backguard
A. Three front screws (4 rear screws required but not shown)
Attaching the Island Trim
A. Center hole not used
4. Using 2 or more people, tip the range back so that the front
feet lift off the ground. Slide range toward the wall until the
rear brace is under the anti-tip bracket. Stand range up,
making sure the anti-tip bracket catches the rear brace.
A
A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dual fuel convection range9760618b

Table of Contents