Specifications; Location Requirements - Whirlpool 3LWTW4840YW Product Manual

Parts supplied:
NOTE: All parts supplied for installation are in the
cardboard insert in the top of the washer.
Drain hose with clamp,
form, and cable tie
Inlet hoses
Plugs and cord lock cover
Alternate parts:
(Not supplied with washer)
Your installation may require additional parts. To order, please
contact the dealer from whom you purchased your washer or
an authorized service company.
If you have:
Overhead sewer
25 mm (1") standpipe
Drain hose too short
Lint clogged drain
"Y" connector
Rubber washer
You will need:
Standard 76 L (20 gal.) 990 mm (39")
tall drain tub or utility sink, sump
pump and connectors (available
from local plumbing suppliers)
51 mm (2") diameter to 25 mm (1")
diameter Standpipe Adapter
Part Number 3363920
Connector Kit Part Number 285835
Extension Drain Hose Part
Number 285863
Connector Kit Part Number 285835
Drain Protector Part Number 367031
Connector Kit Part Number 285835

SPECIFICATIONS

Technical Specifications:
220–240 V ~50 Hz. AC, 1ph 650 Watts, IP24
Dry Linen Capacity
10,5 kg (23 lb)
These units are sold in multiple regions with different
requirements for measuring capacity. Below are a few
of the valid forms of measure posted on this product:
Dry Linen Capacity: A weight measure that reflects a maximum
load size that can be loaded into the washer.
IEC Capacity: The capacity measure that represents the
maximum capacity of dry linens and textiles which the
manufacturer declares can be treated in a specific cycle.

LOCATION REQUIREMENTS

Select proper location for your washer to improve performance
and minimize noise and possible "washer walk". Install your
washer in a basement, laundry room, closet, or recessed area.
699 mm
(27
1067 mm
(42")
You will need:
A water heater set to 49° C (120° F).
n
An earthed electrical outlet located within 1,2 m (4 ft) of power
n
cord on back of washer.
Hot and cold water faucets located within 0,9 m (3 ft) of hot
n
and cold water fill valves on washer, and water pressure
of 20-100 psi (138-690 kPa).
A level floor with maximum slope of 25 mm (1") under entire
n
washer. Installing on carpet is not recommended.
Floor must support washer's total weight (with water and load)
n
of 143 kgs (315 lbs).
IMPORTANT: Do not install, store, or operate washer where it will
be exposed to weather or in temperatures below 0° C (32° F).
Water remaining in washer after use may cause damage in low
temperatures. See "Washer Care" in your Use and Care Guide
for winterizing information.
Proper installation is your responsibility.
IEC Capacity
7,5 kg (16,5 lb)
686 mm
/ ")
1
(27")
2
3