Advertisement

THE ARTICLES MENTIONED BELOW ARE APPLICABLE ONLY FOR
THE UNITED STATES AND CANADA.

1. NOISE EMISSION WARRANTY

SANYANG INDUSTRY CO.,LTD. warrants that this exhaust system, at the time of sale,
meets all applicable U.S. EPA Federal noise standards. This warranty extends to the first
person who buys this exhaust system for purposes other than resale, and to all subsequent
buyers. Warranty claims should be directed to:
3,chung-Hua Road, Hukou, Hsin-Chu Taiwan, R.O.C
Tel:+886 35981911

2. TAMPERING WARNING

Tampering with noise control system prohibited. Federal law prohibits the following acts or
causing thereof:
(1) The removal or rendering inoperative by any person other than for purposes of
maintenance, repair, or replacement, of any device or element of design incorporated
into any new vehicle for the purpose of noise control prior to its sale or delivery to the
ultimate purchaser or while it is in use, or
(2) The use of the vehicle after such device or element of design has been removed or
rendered inoperative by any person.
Among those acts presumed to constitute tampering are the acts listed below.
(1) Removal of or puncturing the muffler, baffles, header pipes or any other component
which conducts exhaust gases.
(2) Removal or puncturing of any part of the intake system.
(3) Lack of proper maintenance.
Replacing any moving part of the vehicle, or parts of the exhaust or intake system, with parts
other than those specified by the manufacturer .

3. SAFETY INFORMATION

 Always wear your helmet (dot approved) correctly fastened. Do not carry loose items and
always wear suitable protective clothes, and protective eyewear.
 Good psychophysical conditions are very important for safe operation.
 Do not operate under the influence of drugs and/or alcohol.
 Do not operate in state of physical fatigue or drowsiness.
 Slow down on slippery surfaces, unfamiliar terrain and when visibility is reduced.
 Be alert when operating this vehicle.
 Do not exceed weight capacity.
 The safety, stability and handling of this scooter may be adversely affected by the addition
of accessories or luggage.
 Do not install accessory or replacement parts not approved by sym.
 Failure to follow these warnings could lead to an accident, serious injuries or death.
 Use unleaded fuel octane rating (R+M)/2 method of between 87&92.
 Read owners manual carefully before operating this scooter.
 Obey posted speed limit and other traffic signs and signals.
Fax:+886 35981844
80
t

Advertisement

Table of Contents
loading

Summary of Contents for Sym Symba 110 MB10A7 Series

  • Page 1: Noise Emission Warranty

     The safety, stability and handling of this scooter may be adversely affected by the addition of accessories or luggage.  Do not install accessory or replacement parts not approved by sym.  Failure to follow these warnings could lead to an accident, serious injuries or death.
  • Page 2 4. SAFETY DEFECT REPORT SANYANG INDUSTRY CO., Ltd. NO. 3,chung-Hua Road Hukou Shiang Hsin-Chu County, 303 Taiwan, R.O.C Reporting Safety Defects If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying Sanyang Industry Co., Ltd.
  • Page 3: Table Of Contents

    1. Contents ........................1/2 2. Control Location ....................... 3 3. Before Riding ........................4 4. Safe Riding ........................4 5. Driving ..........................5 6. Use Genuine Spare Parts ....................5 7. Use of Each Component ....................6 ..........................6 Gauges ....................
  • Page 4 10. Inspection and Maintenance before Riding ....................20 Check for Fuel Leakage ...................... 20 Check the Air Cleaner 11. When there is an Abnormal Condition ................21 ................21 Diagnosis when Engine does not Start 12. C.D.I. Electrical Ignition System ................... 22 13.
  • Page 5: Control Location

    Light / Starter switch Front brake lever Rear brake pedal High & Low beam / Turn signal / Horn switch Air cleaner Front light Fuel tank cap Frame number Tool bag Center stand Shift pedal Side stand Back mirror Ignition switch Fuses &...
  • Page 6: Before Riding

    This manual describes the correct usage of the SYMBA including: inspection and safe riding techniques. For a safe and enjoyable ride, please read this manual carefully. For your benefit, please ask your SYM dealer for the operating manual and carefully read the following: ...
  • Page 7: Driving

    Also, it may result in unexpected troubles and lower the SYMBA’s performance. ●Always use SYM Genuine Spare Parts to keep your scooters pure blood and to ensure its long service life.
  • Page 8: Use Of Each Component

    The following is SYM’s 4 stroke air cooled 101.4c.c. SYMBA. Please refer to page 24 of this manual for specific specifications. GAUGES Odometer Speedometer Gear Indicator Turn Signal Indicator High Beam Indicator Fuel Gauge Speedometer: This shows your speed in miles per hour (outer-mph) and in kilometer per hour (km/h-inner).
  • Page 9: Operation Of Ignition Switch

    OPERATION OF IGNITION SWITCH IGNITION SWITCH “Start” position  Engine can be started in this position.  Ignition switch key can not be removed. “Stop” position  Engine is shut off and can not be started in this position.  Ignition switch key can be removed. “Handlebar lock"...
  • Page 10  Electrical Starter Button This is the electric start button (switch) for starting the engine. With the main switch "ON", pressing this button while holding the front or rear brake lever will start the engine. CAUTION:  Release this button immediately after the engine has been started and don’t press the button again to avoid damaging the engine.
  • Page 11: Fuel Tank Cap

    FUEL TANK CAP 【Fuel refilling】 Fuel capacity: 1.08 Gal Fuel tank cap When refueling, raise the seat and turn the fuel filler cap counter-clockwise. Use unleaded gasoline. DANGER:  Center stand should be put down on the ground, engine should be shut off and flames should be strictly prohibited to ensure safety when refueling.
  • Page 12: Important Points And Cautions For Starting Engine

    CAUTION:  Check the engine oil and fuel levels before starting the engine.  To start engine, the main parking stand be in the down position. The rear brake lever must be depressed and the rear brake applied before the engine will start. This safety feature ensures that the scooter will not surge forward when started.
  • Page 13: The Best Way To Operate Your Symba

    【When starting engine with Kick starter pedal】  After step 1 is completed, push the kick starter lever forcefully by foot with the throttle handle at the closed position.  If the engine is difficult to start with the kick starter lever when the engine is cold, try rotating the throttle handle 1/8 to 1/4 turn to make starting easier.
  • Page 14: The Control Of Throttle Valve Handle

    THE CONTROL OF THROTTLE VALVE HANDLE Acceleration: To increase speed when riding on an Deceleration inclined road, turn the throttle handle slowly to allow the engine to Acceleration increase its power. Deceleration: To decrease speed. PARKING METHOD  When parking your scooter you should: 1.
  • Page 15: Inspection And Maintenance Before Riding

    CAUTION:  If any problem is found during routine inspection, correct the problem before using the scooter again. Have your scooter checked and repaired by an authorized “SYM dealer or authorized service personnel” if necessary. ENGINE OIL INSPECTION AND CHANGE INSPECTION: 1.
  • Page 16: Fuel Inspection

    ※Recommended Oil: SYM Genuine EXTRA 4X OIL.  Oil Capacity : 1.0 Liter (0.8 liters for routine change), oil filter change: 0.8 liters. 【Oil Filter Cleaning】 Open the filter nut assembly of the element, and remove the element. Remove the foreign materials from the element by using a gasoline or air pressure.
  • Page 17: Inspection And Adjustment Of Brake Free Play

    INSPECTION AND ADJUSTMENT OF BRAKE FREE PLAY INSPECTION: (Brake lever free play must be checked with the engine shut off.)  Brake lever free play for front and rear wheels: Check the hand-brake lever for front and rear wheels. Its free play (the stroke of hand-brake lever from no braking to initial braking) should be 10~20mm.
  • Page 18: Throttle Valve Handle Clearance Adjustment

    Brake shoe check: Apply both the front and rear brake. If the arrow aligns with the reference mark on full application of the brake, the brake shoes will need to be replaced by your authorized SYM dealer. Mark Arrow Arrow...
  • Page 19: Drive Chain Lubrication

    DRIVE CHAIN ADJUSTMENT Check the drive chain for wear and tension. If it appears dry, apply a lubricant. 10~20 mm  Place the scooter on the main stand. Shift the transmission into (1/3~1/2 IN) neutral.  Move the chain up with your fingers at a point midway between the sprockets.
  • Page 20: Tire Inspection

     Check the steering handle to see if it is being pulled too tightly by the brake cables.  Take your scooter to an SYM Authorized Dealer for service if any abnormal conditions are found. 10. Inspection and maintenance before riding...
  • Page 21: Checking And Changing Fuses

    CHECKING AND CHANGING FUSES  Turn the ignition switch “OFF”. Remove the left side cover.  The fuse is installed in the fuse holder, located near the battery.  Open the fuse holder and lift out the clips with the fuse. Slide the clip off of the end of the fuse. ...
  • Page 22: Check For Fuel Leakage

    Rear brake light adjustment: Check the operation of the brake light switch  at the right side behind the engine from time to time. Adjustment is done by turning the adjusting nut . Turn the nut in the direction (A) if the switch operates too late and in direction (B) if the switch operates too soon.
  • Page 23: When There Is An Abnormal Condition

    (5). Turn the ignition switch key “ON”, and press horn button down. If the horn does not sound, the fuse may have been blown. 【Have your scooter checked by an SYM authorized dealer immediately if there are no problems with the above items and the engine still can not be started.】...
  • Page 24: Electrical Ignition System

    The charge and discharge principle of a condenser is adopted for the C.D.I system to supply electrical energy created by generator’s coil, to the ignition coil in accordance with specified ignition timing so that the spark plug may generate sparks as required 13.
  • Page 25: Periodical Maintenance Schedule

    ☆The above maintenance schedule is established by figuring a usage of 1000 miles per month. Please use the above information as a reference. Your personal riding may vary. ※Have your scooter checked and adjusted periodically by your SYM Authorized Dealer to maintain the scooter at the optimum performance and condition.
  • Page 26: Specification

    Model SYMBA 110 MB10A7 SERIES Item Specification Length/ Width / Height 1,910 mm(75.2 in) / 690 mm(27.2 in) / 1,055 mm(41.5 in) Seat height 760 mm(29.9 in) Wheel base 1,225 mm(48.2 in) Net Weight 95 kg(209 lb) maximum load 170 kg (374 lb) Type 4- stroke single cylinders engine Fuel...

Table of Contents