Janome Skyline 55 Instruction Book page 48

n
m
,
n The buttonhole is sewn automatically in the sequence
shown. When the buttonhole is nished, the machine
will stop automatically with the needle in the up
position.
Press the thread cutter button and remove the fabric.
NOTE:
If you start sewing without pulling down the buttonhole
lever, the LCD screen will show a warning and
the machine will stop after a few stitches. Pull the
buttonhole lever down and start sewing.
m After you nish buttonhole sewing, push the
buttonhole lever up as far as it will go.
, Place a pin just below the bartack at each end to
prevent accidentally cutting the threads. Cut the
opening with the seam ripper. Use an eyelet puncher
to open a keyhole buttonhole.
NOTE:
To make a solid and sturdy buttonhole, sew another
layer of buttonhole over the previous one.
After the buttonhole is nished, simply press the start/
stop button again.
Do not raise the foot or reselect the pattern.
The machine will sew another buttonhole over the
previous one.
46