Mercedes-Benz Vito Supplement Owner's Manual page 37

Practical advice
Installing the two-way radio
Guide two-way radio connection cables
a through the centre console upwards
into the two-way radio installation
space.
i
Tie back the connection cables and
connector in the lower area of the cen-
tre console ( page 33).
Connect the two-way radio in accord-
ance with the manufacturer's wiring
3
diagram.
Pin assignment for two-way radio con-
nector ( page 40) and aerial
( page 39).
Press two-way radio mounting frame
c with the two-way radio into the
installation space.
34
Tighten Torx screws b on two-way
radio mounting frame c or the double
mounting frame.
Fit trim 1 on the centre console.
Make sure that the clamps on the trim
engage.
Refit trim 9. Take care not to damage
the bulb holder in the ashtray light and
the cigarette lighter connection cable
when doing this.
Insert the bulb holder for the ashtray
light into the ashtray housing.
Refit ashtray 3 and the insert in the
centre console.
Re-insert cigarette lighter 4 in its
socket.
Replace gear lever cover 7 on
trim 9.
Refit lower section of the centre con-
sole* 6 or the footwell trim. Take care
not to damage the two-way radio loud-
speaker in the front-passenger footwell
when doing this ( page 15).
Reconnect the battery.
Disconnect the quiescent current
retention unit.
Carry out a function check on the two-
way radio.
Two-way radio operation ( page 18)