Table of Contents
Advertisement
Operation
Operation
Pressure Relief Procedure
Follow Pressure Relief Procedure when you stop
spraying and before cleaning, checking, or servicing
equipment. Read warnings, page 2.
1.
Turn off gun air supply.
2.
Trigger the gun to relieve pressure.
Flushing
Flush before using the equipment, before changing
colors, and when you are done spraying. Use solvent
that is compatible with gun wetted parts and fluid that
will be sprayed. Flush at lowest possible pressure.
NOTE: Refer to Compliant Cleaning Methods, page 5,
to comply with air quality laws if applicable.
1.
Follow Pressure Relief Procedure.
2.
Dispose of any paint in cup.
3.
Fill cup with small amount of solvent.
4.
Spray into grounded metal waste container until
equipment is clean.
5.
Follow Pressure Relief Procedure.
4
Spraying
Excessive atomizing air pressure can increase
over-spray, reduce transfer efficiency, and result in a
poor quality finish from dry spray.
1.
Fill cup (101) with material. Do not fill past cup
"shoulder" (A). See F
2.
Screw cup (101) onto lid securely.
3.
Slowly adjust gun air pressure while fully triggering
the gun until you have the desired atomization.
4.
Adjust the pattern size and shape with the spray
width adjustment knob (10). See F
clockwise to reduce pattern size and counterclock-
wise to increase it.
NOTE: See Troubleshooting guide if you experience
an irregular pattern.
5.
Fluid control knob (7) is factory set for maximum
needle trigger travel and material flow. To decrease
needle/trigger travel and decrease fluid flow, turn
knob clockwise.
10
F
. 2
IG
NOTICE
. 1.
IG
. 2. Turn knob
IG
7
Advertisement
Table of Contents
