Table of Contents
Advertisement
Operating Hints GT 2005 / 2105
Note: This chapter contains excerpts from the operating instructions. For further particulars please refer to the appropriate user instructions the part number of which is indicated in the relevant spare parts list.
TUNING IN
TUNING
Your TV set can memorise 99 different channels.
During channel tuning any connected satellite receiver
or video recorder should be switched to standby. To
tune in different channels, follow the instructions below.
Step 1
Press TUNE on the remote control.
A tuning bar will appear.
Step 2
Press P+ for approximately one second.
The set will scan up through the available channel
frequencies. A cursor moves slowly up the bar until
'S'
a channel is found. The S will now flash on and off.
If you do not wish to store the channel, press P+
again until a required channel is found.
Step 3
Press STORE to memorise the channel.
The programme setting PO1 will now flash on and off.
Step 4
Decide which channel number you want to allocate
the channel to e.g. BBC1 = 1. Press the appropriate
number e.g. 1.
Step 5
Store the setting by pressing STORE.
The channel is now stored against the chosen channel
number. The tuning bar will still be on screen and the
S will still flash.
Now tune the remaining channels. Repeat steps 2, 3, 4
and 5 until all channels are tuned in.
To exit the tuning screen press TV.
FINE TUNING
After following the TUNING instructions you should
have a clear picture on all channels (subject obviously
to the reception quality of the incoming signal). If any
channels are not to the standard you would expect,
fine tuning may sometimes improve the picture quality.
To fine tune follow the steps below:
Step 1
Select the channel to be tuned. If the tuning bar is no
longer on screen press TUNE. If it is, move onto step 2.
Step 2
Press HOLD very briefly. An X will appear besides the
programme number to indicate that fine tuning has
been selected.
Step 3
By briefly pressing P+ or P-, fine tune the picture.
Step 4
When the best possible picture has been achieved,
press STORE twice to memorise the settings.
Step 5
To return to normal television viewing press TV.
Note : the X symbol means that the Automatic
Frequency Control (AFC) has been switched off.
Channels stored with the X displayed may drift off
tune and therefore fine tuning should only be used if
absolutely necessary.
TUNING INTO A VIDEO RECORDER,
SATELLITE RECEIVER OR GAMES CONSOLE
If connecting a video recorder, satellite receiver or
games console to the television set via the scart
sockets (see page 3 and 14), press 0/AV on the
remote control. Alternate presses of 0/AV selects
between the AV inputs, AV1 and AV2.
If making the connection via the television sets aerial,
x2
select channel 99 as the dedicated channel by
pressing 9 twice.
5
6
Advertisement
Table of Contents
