One for All OARN08G User Manual page 13

Learning From Your Original Remotes
1. Place your original remote and the learning remote on a
flat surface as shown below. Point the top of your original
remote at the top of the learning remote. The IR LED on
the original remote should be pointing directly at the
learning remote's learning sensor, located on the top of the
remote. The remotes should be 1–2 inches apart.
2. On the learning remote, press and hold
the device key you want to use the
learned function in (the POWER key
turns on and remains on). While holding
down the device key, use your other
hand to press and hold the RECORD key
(the POWER key illumination turns off).
3. Wait until the POWER key turns on and
stays on. Then release both keys. The
remote is now in Learning mode.
4. On the learning remote, press the
key you want to use for the learned
function. The illuminated POWER key
blinks once, then remains on.
5. On the original remote, press and hold the key you want
to teach to the universal remote. Wait until the POWER key
on the learning remote blinks once, then release the key
on the original remote. The learning remote has finished
learning this key.
Note:
6. To learn another key for this device mode: Repeat steps
4 and 5 for the key you want to learn.
To learn keys in a different device mode: Repeat steps
2–5 for the next device mode.
To save learned keys and exit learning: press the SLEEP
key on the learning remote.
Learning Tips
sources.
universal remote so that the Learned key is assigned to
the correct mode.
Punch Through mode.
from your original remote.
1–2"
13