Standard Signal Mode Table - Samsung SMT-1914 User Manual

9
Specifications

9.4 Standard Signal Mode Table

This product can be set to only one resolution for each screen size to obtain the optimum picture
quality due to the nature of the panel. Therefore, a resolution other than the specified resolution
may degrade the picture quality. To avoid this, it is recommended that you select the optimum
resolution specified for the screen size of your product.
Check the frequency when you exchange a CDT monitor (connected to a PC) for an LED monitor.
If the LED monitor does not support 85Hz, change the vertical frequency to 60Hz using the CDT
monitor before you exchange it with the LED monitor.
If a signal that belongs to the following standard signal modes is transmitted from your PC, the screen will
automatically be adjusted. If the signal transmitted from the PC does not belong to the standard signal
modes, the screen may be blank even though the power LED turns on. In such a case, change the
settings according to the following table by referring to the graphics card user manual.
SMT-1914
Resolution
IBM, 640 x 350
IBM, 720 x 400
IBM, 640 x 480
MAC, 640 x 480
MAC, 832 x 624
MAC, 1152 x 870
VESA, 640 x 480
VESA, 640 x 480
VESA, 800 x 600
VESA, 800 x 600
VESA, 800 x 600
VESA, 800 x 600
VESA, 1024 x 768
VESA, 1024 x 768
Horizontal Vertical
Frequency Frequency
(kHz) (Hz)
31.469 70.086
31.469 70.087
31.469 59.940
35.000 66.667
49.726 74.551
68.681 75.062
37.861 72.809
37.500 75.000
35.156 56.250
37.879 60.317
48.077 72.188
46.875 75.000
48.363 60.004
56.476 70.069
Pixel Clock Sync Polarity
(MHz) (H/V)
25.175 +/-
28.322 -/+
25.175 -/-
30.240 -/-
57.284 -/-
100.000 -/-
31.500 -/-
31.500 -/-
36.000 +/+
40.000 +/+
50.000 +/+
49.500 +/+
65.000 -/-
75.000 -/-
9 Specifications
62