JVC XV-N420B Service Manual page 12

3.2 Loading mechanism assembly
3.2.1 Removing the traverse mechanism assembly (See Figure 1)
(1) Reverse the loading mechanism assembly.
(2) A card wire is removed from a wire bracket.
(3) Remove the four screws A attaching the traverse mecha-
nism assembly. Remove the traverse mechanism assem-
bly upward.
3.2.2 Removing the elevator (See Figure 2 and Figure 3)
• Prior to the following procedure, remove the traverse mecha-
nism assembly.
(1) Remove the two arms of the elevator from the two parts a
by moving the arms in a direction of the arrow.
(2) Pull out the elevator in a rear direction.
Attaching the elevator:
Engage the two holes b to the two shafts on the front part of
the elevator. And then, attach the elevator.
1-12 (No.YD054)
Loading mechanism assembly
A
A
Traverse mechanism assembly
Part a
Elevator
Shaft Shaft
A
wire
bracket
A
Fig.1
Elevator
Part a
Fig.2
b
Slide cam
b
Fig.3