Hoover HWC 2335 Instruction Booklet page 8

CARE AND MAINTENANCE
CHANGING THE LED LIGHT
Note: All parts removed must be saved to do the replacement of the LED
light. Before removing the LED light, either unplug the refrigerator or
disconnect the electricity leading into the refrigerator at the main power
supply. Failure to do so could result in electrical shock or personal injury.
You should use the LED light which is permitted by the seller.
Cleaning Your Wine Cooler
Unplug the wine cooler, and remove the bottles.
Wash the inside with a warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a quart of water.
Wooden shelves does not require cleaning.
The outside of the wine cooler should be cleaned with mild detergent and
warm water.
It may also be necessary to periodically wipe the bottom part of the storage
area, as the wine cooler is designed to retain humidity, and condensation
may collect there.
Maintenance of Your Wine Cooler
Power Failure
Most power failures are corrected within a few hours and should not
affect the temperature of your wine cooler if you minimize the number
of times the door is opened. If the power is going to be off for a longer
period of time, you need to take the proper steps to protect your contents.
Vacation Time
During long absences, remove all the bottles; unplug your wine cooler,
clean your wine cooler, and leave the door open slightly to avoid possible
formation of condensation, molder, or ordure.
Moving Your Wine Cooler
Remove all the bottles.
Securely tape down all loose items inside your wine cooler.
Turn the levelling screws up to the base to avoid damage.
Tape the doors shut.
Be sure the wine cooler stays in the upright position during transportation.
7