Sizing Pto - King Kutter Rotary Mower Operation And Parts Manual

SIZING PTO SHAFT
STEP 1
Cutting the PTO shaft to length.
NOTE: Be sure to cut equal lengths
of each PTO shaft section. Clamp
end of PTO shaft in a vice and cut
off shield where marked.
1-A & 1-B)
STEP 2
Using cut section of the shield as a
guide cut shaft off the same amount.
(Figure 2)
STEP 3
Repeat steps 1 and 2 for other PTO
shaft section.
STEP 4
Use a file to deburr PTO shafts.
Clean up all chips, burrs and filings
from both ends of the PTO shaft.
(Figure
Figure 1-A
Figure 1-B
Figure 2
19