Introduction To The T7F-2.4Ghz System; Transmitter Controls And Descriptions; Product View - RadioLink T7F-2.4Ghz Instruction Manual

7-channel, fhss for airplanes/helicopters

Table of Contents

IMPORTANT!: Always turn on the transmitter first, then the receiver. When turning off the system, always turn off the

receiver first. The object is never to have the receiver on by itself. Otherwise, the servos or control surfaces could be

damaged, or in the case of electric-powered models, the motor may unexpectedly turn on causing severe injury.

Transmitter

ACRO mode: External switches operate dual rates (D/R), landing gear, and trainer cord or "buddy-box" capabilities.

Programming features include servo reversing and E.P.A on all channels, dual rates, exponentials and programmable

mixing. Additionally, any one of four, factory-set, preprogrammed "wing-type" mixers including flaperon, and V-tail,

elevon mixing may be selected.

HELI mode: Dual rate (D/R), Idle up, Throttle hold, and Gyro sense can be operated by switch. Two different gyro

senses can be set with RadioLink GY100 Gyro on gyro function of this transmitter. Programming features include

servo reversing and E.P.A on all channels, dual rates, exponentials, throttle curve, pitch curve, throttle hold, and pit to

rudder mixing(REVO). Additionally, any one of two, factory-set, preprogrammed "swashplate type" mixers, including

three servo type 3-S, may be selected.

Transmitter controls

The diagram and explanations briefly describe the functions of the RadioLink T7F-2.4GHz transmitter.

on how to operate the controls are provided beginning on page 11.

Mode 1:Throttle on the right. Mode 2:Throttle on the left. (More on flight modes on page 28)

Carrying handle

A:Gear switch(CH.5)

H:Gyro switch(CH.5)

Traner switch

Idle-up switch

Throttle trim lever(Mode 2)

Elevator trim switc(Mode 1)

Throttle/rudder control

stick(Mode 2)

Elevator/rudder control

stick(Mode 1)

Rudder trim lever

MODE

"▲" key

DATA "+" key

DESCRIPTIONS:

Aileron, Elevator and Rudder dual rate switch

Use this switch to "flip" between two aileron, elevator and rudder control throw settings. The throws can be set up

however you prefer, but generally, when the switch is "up" the throws are greater ("high rate") and when the switch is

"down" the throws are less ("low rate"). This switch also flips between exponential rates (if used).

A:Flap switch/Channel 6 - This switch operates the servo connected to channel 6 in the receiver. If your model has

flaps, this is the control used to operate them.