Display In Manual Mode - Kemppi MinarcMig 180 Operation Instructions Manual

MinarcMig™ Adaptive 180
If, on the other hand, you want to weld with a colder arc to prevent for example
the parent material from burning through, adjust the arc shorter by turning the
control counter clockwise. You can also adjust the welding power, if need be.
When adjusting the arc length, the weld on the arc trimmer chart on the display
correspondingly changes more concave or convex.
Once the arc has been trimmed, it usually does not need to be changed when
the welded sheet thickness changes.

3.5.4. Display in manual mode

en
Figure 3.8. Machine display in manual mode
1. Operating mode
2. Wire feed speed chart
3. Welding values: wire feed speed, welding voltage and welding current
The selected operating mode is visible on the display. During welding, the wire
feed speed chart displays the wire's speed.
Wire feed speed is the only welding parameter always visible on the display.
When adjusting welding voltage, the display shows the set value for the
voltage, and only during welding does the display show the actual value.
Welding current is visible on the display only during welding.
Values for actual welding voltage and welding current remain on the display
after welding until welding is restarted or settings are changed.
16 © Kemppi Oy 0640