Advertisement
Quick Links
VGA Monitor, Keyboard, and Mouse
Long Range CAT5 Extender
Model: VGPS2100C
Features:
• Extend VGA and Keyboard mouse over 2 CAT5 UTP cables.
• Includes local and remote units.
• Distance ranges up to 300ft / 100m via standard 4 pairs CAT5 UTP or STP cable instead of VGA
cable.
• Built-in dip switch for compatibility with all monitors when using CAT5 UTP cable.
• Supports up to 1280x1024 pixels at 200ft / 60m.
• Passive device; Does not support VGA DDC protocol.
• Perfect for classrooms, lecture halls, tradeshows, video information displays...etc.
Wiring Diagram:
Panel View:
Max. Distance via CAT 5 Cable
800x600 pixels (30MHz)
1024x768 pixels (60MHz)
1280x1024 pixels (100MHz)
Cabling Systems & Solutions
Rev092007
Front
300ft / 100m
250ft / 75m
200ft / 60m
Rear
UTP = Unshielded Twisted Pair
VG01
Advertisement
Related Manuals for Oki VGPS2100C
Summary of Contents for Oki VGPS2100C
- Page 1 VGA Monitor, Keyboard, and Mouse Long Range CAT5 Extender Model: VGPS2100C Features: • Extend VGA and Keyboard mouse over 2 CAT5 UTP cables. • Includes local and remote units. • Distance ranges up to 300ft / 100m via standard 4 pairs CAT5 UTP or STP cable instead of VGA cable.
- Page 2 Specification: Model VGPS2100C Environment VGA. VESA VP&D 1.0, VIP ver 2.0 Devices VGA monitors, LCD projection screen, Laptops, PCs. Video : 1.1V P-P Input Signals Horiz & Vert Sync : TTL standard. 300kHz max. bandwidth Insertion Loss Less than 3dB per pair over the frequency range...
- Page 3 If your RJ45 connector is plastic housing (unshielded), then the cable connection must do the following: The ground cable must pull out around 5-10cm length to connect with VGA Extender’s ground screw for grounding. Make the ground cable connect to ground screw, then plug RJ45 connector. Installation: CAUTION: Make sure to follow this instruction for DIP switch setting when using CAT5 UTP cable.
- Page 4 Troubleshooting at picture problem: 1. Picture disappear intermittence or no picture display: Please adjust the Dip switch setting or change the vertical SYNC frequency of the VGA display card, DVR. 2. Display not syncing up properly: There are some certain models or brands of monitors with very high demand at sync-sensitive and the DIP switch setting may not compensate properly.