Completing The Set Up - Samsung SRF680CDLS User Manual

Parts for water line Installation
Water line fixer and screws
Water line
Connecting to the water supply line
1. First, shut off the main water supply line.
2. Locate the nearest cold, drinking water line.
3. Follow the Water line Installation Instructions in
the installation kit.
CAUTION
The water line must be connected to
the cold water pipe. If it is connected
to the hot water pipe, it may cause the
purifier to malfunction.
Close Main
Water pipe
Close Main
Water pipe
4. After connecting the water supply to the water
filter, turn your main water supply back on
and dispense about 3L to clear and prime the
water filter.
Connecting the water line to the
refrigerator
1. Remove the cap from the water line on the unit
and insert the compression nut of the water
line into the water line on the unit.
2. Connect the water line on the unit with the
water line in the kit .
3. Tighten the compression nut onto the
DA68-02916A (EN)-04.indd 21
4. Turn water on and check for any leakage.
Pipe connector
• Samsung Warranty does not cover
• It will be done at
• Please contact Plumber or Authorized Installer
• If Water leakage occurs due to improper
No gap

COMPLETING THE SET UP

Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1. Make sure your refrigerator is in an appropriate
2. Once the refrigerator is plugged in, make sure
compression fitting. There should be no gaps
between (A, B & C )
Only connect the water line to a drinkable
water source. If you have to repair or
disassemble the water line, cut off 6.5mm
of the plastic tubing to make sure you get
a snug, leak-free connection.
Remove
Loosen a
cap
Water Line
from unit
Water Line
from Kit
Before being used, the leakage in these
places should be examined.
CAUTION
WATER LINE
INSTALLATION.
customer's charge
unless the retail
price includes
installation cost.
for the installation if needed.
installation, Please contact installer.
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
the interior light comes on when you open the
No gap
setting up _21
13. 7. 24. 4:59