Completing The Set Up - Samsung RF28HM SERIES User Manual

2.Tighten the compression nut ( B)onto the
compression fitting.
Do not o ver-tighten the compression nut ( B).
3oTurn t he water onand check forany leakage.
Ifyou find water drops orleakage inthe
connection areas, turn off t he main w ater
supply. Check the connections and, if
necessary, tighten.
4. Flush 1gallon ofwater through the filter
before drinking orusing the water from the
refrigerator. (Flush approximately 6minutes.)
To flush, press alarge glass orcup against the
water dispenser lever. Fill the glass, empty it
into the kitchen sink a fter itisfilled, and then
repeat.
5.After you turn onthe refrigerator, let t he ice
maker make ice for1to2days. Over that
period oftime, throw out t he first 1 or2
buckets ofice the freezer makes toensure all
impurities have been r emoved from the water
line.
Only c onnect the water line t oadrinkable
water source.
Ifyou have torepair ordisassemble the water line,
cut o ff 1 /4" o fthe plastic tubing tomake sure y ou
get a snug, leak-free connection.
You c an test t he water line quickly using a
paper cup. Under normal conditions, the
water dispenser can fill a 5.75 oz. ( 170cc)
cup inabout 10seconds.
COMPLETING THE SET UP
Now that you have your new refrigerator installed
in place, you are ready to set up and enjoy the
features and functions of the appliance.
By completing the following steps, your refrigerator
should be fully operational.
1.
Make sure your refrigerator is in an appropriate
location with reasonable clearance between it
and the wall. Refer to installation instructions in
this manual.
2. Once the refrigerator is plugged in, make sure
the interior light comes on when you open the
doors.
3o Set the Temperature control to the coldest
temperature and wait for an hour. The freezer
will get slightly chilled and the motor will run
smoothly. Reset the refrigerator and freezer to
the temperatures you want.
4. After you plug the refrigerator in, it will
take a few hours to reach the appropriate
temperature. You can store food and drinks
in the refrigerator after the temperature is
sufficiently cool.
If condensation or water drops appear
on both sides of the fridge door's central
part, turn the Energy Saver mode off after
removing the condensation. (See the
explanation of the Energy Saver button in
"Using the Control Panel" on page 18.)
Engl sh - 17