IBM BladeCenter T 8720 Installation And User Manual page 32

To reduce the possibility of electrostatic discharge, observe the following
precautions:
v Limit your movement. Movement can cause static electricity to build up around
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed printed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the system unit
v Take additional care when handling devices during cold weather. Heating reduces
18
BladeCenter T Types 8720 and 8730: Installation and User's Guide
you.
metal part of the system unit for at least 2 seconds. This drains static electricity
from the package and from your body.
without setting the device down. If it is necessary to set down the device, place it
back into its static-protective package. Do not place the device on the system
unit or on a metal surface.
indoor humidity and increases static electricity.