CENTRAL SERVICE CENTER 16. Always connect a test instrument's ground 10. Service technicians should remove their lead to the instrument chassis ground before watches while repairing an MWO. connecting the positive lead; always remove the instrument's ground lead last. Samsung Electronics...
PRECAUTION DO NOT measure the voltage in the high voltage circuit including filament voltage of magnetron. Servicemen should remove their watches whenever working close to or replacing the magnetron. Samsung Electronics...
2. Specifications 2-1 Table of Specifications MODEL MW5580W ITEM TIMER 99 MINUTES 99 SECONDS POWER SOURCE 120V/60HZ, AC POWER CONSUMPTION MICROWAVE : 1,500W OUTPUT POWER FROM 100W TO 1000W (IEC-705 TEST PROCEDURE) OPERATING FREQUENCY 2,450MHz MAGNETRON OM75P COOLING METHOD COOLING FAN MOTOR OUTSIDE DIMENSIONS "(W) x 12...
Pause Start food between cooking stages, Cancel PAUSE/CANCEL or to set a kitchen timer. Press once to pause; twice to MW5580W cancel. 3-2 Features & External Views Ventilation Holes Light Door Safety Interlock Holes One Minute +...
1. Discharge the high voltage capacitor. 2. Disconnect all the leads from the high voltage transformer. 3. Remove the mounting bolts on the high voltage transformer. 4. When replacing, connect the leads correctly and firmly. H. V. Trans Samsung Electronics...
1. Push key door upward and remove it. Key Door 2. Detach spring from Door "A" and key door. Hook to hang the key spring Push door key in this direction Spring to pull it out. Door "E" Samsung Electronics...
. Drive Motor 8. Connect all the leads to the drive motor. 9. Screw the drive motor cover to the base plate with a screw driver. 10. Remount the coupler in the correct poaition. Samsung Electronics...
Therefore, applying hot air such as using of hair dryer is recommended for smoother removal. 6. When installing new membrane key board, make sure that the surface of escutcheon base is cleaned enough to prevent any problem (shorted contacts or uneven surface). Samsung Electronics...
3. Before touching any oven components or wiring, always unplug the oven from its power source and discharge the high voltage capacitor. 5-1 High Voltage Transformer Filament Terminals 1. Remove connectors from the transformer terminals and check continuity. 2. Normal resistance readings are as follows: MODEL MW5580W Secondary 71.0Ω ± 10% Filament Shows Continuity 0.4Ω ± 10% Primary Secondary...
Door Open Door Closed procedures. ∞ Primary switch 5. Confirm that the gap between the switch ∞ Monitor switch (COM-NC) housing and the switch actuator is no more than ∞ Door Sensing S/W 0.5mm when door is closed. Samsung Electronics...
Page 12
5. After heating for 2 minutes, measure the water temperature in each beaker. 6. Microwave heat distribution rate can be calculated as follows: Minimum Beaker Temperature Rise Heat Distribution = X 100(%) Maximum Temperature Rise The result should exceed 65%. Cooking Tray Samsung Electronics...
; CENTRAL SERVICE CENTER 5-13-2 At least once a year have the microwave energy survey meter checked for accuracy by it manufacturer. Samsung Electronics...
H.V.Transformer component test procedure and replace if it is H.V.Capacitor defective. H.V.Diode Magnetron 4. Open or loose wiring of power relay 5. Defective primary latch switch 6. Defective power relay or Ass'y PCB Replace PCB main. Samsung Electronics...
Page 15
Use plastic wrap or cover with a lid. Stir once or twice while cooking foods such as soup, cocoa, or milk. Noise from the turntable motor Noise may result from the motor. Replace turntable motor. when it starts to operate. Samsung Electronics...
FOR HIGH VOLTAGE LEADS OR AS NOTED ON SPECIAL LEADS. : P.C.B IN/OUT POINT MAGNETRON HIGH VOLTAGE DIODE TO CHASSIS PRIMARY SWITCH HIGH VOLTAGE CAPACITOR DOOR SENSING SWITCH MONITOR SWITCH BOTTOM CENTER SYMBOL COLOR ORANGE HIGH VOLTAGE WHITE TRANSFORMER BLACK BLUE POWER RELAY Samsung Electronics...