DSC SCW9047-433 User Manual page 9

Bypassing Zones
With the system disarmed.
1. Press to enter the function menu. The keypad will display "Press
2. Press or
Bypass Zones".
3. Enter the two-digit number of the zone(s) to be bypassed (01-34).
You can also use the
zone. The keypad will display "Zone Name". "B" will appear on the display to show that the zone is
bypassed. If a zone is open (e.g., door with door contact is open), the keypad will display "Zone Name"
O". If you bypass the open zone, a "B" will replace the "O".
4. To unbypass a zone, enter the two-digit number of the zone(s) to be bypassed (01-34). You can
also use the
disappear from the display to show that the zone is no longer bypassed.
5. To exit bypassing mode and return to the Ready state, press
Activating All Bypassed Zones
To remove bypass (all zones):
1. Press , then your [access code] (if necessary).
2. Press .
3. To exit bypassing mode and return to the Ready state, press
Recalling Bypassed Zones
To recall the last set of bypassed zones:
1. Press , then your [access code] (if necessary).
2. Press .
3. To exit bypassing mode and return to the Ready state, press
Bypass Group
A Bypass Group is a selection of zones programmed into the system. If you bypass a group of zones
on a regular basis, you can program them into the Bypass Group, so that you do not have to bypass
each zone individually every time. Only one Bypass Group can be programmed.
To program a Bypass Group:
1. Press , then your [access code] (if necessary).
2. Enter the two-digit numbers (01-34) of the zones to be included in the Bypass Group or
use the
to select the zone.
3. To save the selected zone into the group, press
4. To exit bypassing mode and return to the Ready state, press
NOTE: If an access code is required to enter bypassing, only the Master Code and codes with
Supervisory enabled can set the Bypass Group.
To select a Bypass Group when arming the system:
1. Press , then your [access code] (if necessary).
2. Press . The next time the system is armed, the zones in this group will be bypassed.
3. To exit bypassing mode and return to the Ready state, press
NOTE: A Bypass Group is only recalled if the system is armed/disarmed after programming the by-
pass group.
NOTE: This feature is not to be used in UL Listed installations.
, then your [access code] (if required). The keypad will display "Scroll to < >
keys to find the zone to be bypassed, and then press
keys to find the zone, and then press
keys to find the zone to be included in the bypass group, then press
to select the zone. The "B" will
.
5
for < > Zone Bypass".
to select the
.
.
.
.
.