Troubleshooting; Specifications - Infinity BassLink Instructions Manual

T
ROUBLESHOOTING
• PROBLEM:
POWER LED not lit.
CAUSES and SOLUTIONS:
1. Fuse is blown and needs replacement.
2. Head unit not functioning properly. Check
remote voltage, and power, ground or
remote connections.
• PROBLEM:
POWER LED is lit but there is no bass.
CAUSES and SOLUTIONS:
1. Inputs are not connected. Check connections.
2. Head-unit fader control is not set properly.
Adjust head-unit fader control to feed audio
signals to BassLink.
• PROBLEM:
BassLink sounds muddy or distorted.
CAUSES and SOLUTIONS:
1. Gain is set too high and SERVO LED is lit
constantly. Readjust GAIN control (see
Tuning BassLink on the previous page).
2. Bass is set too high. Readjust BASS BOOST
control (see Tuning BassLink on the
previous page).
3. Head-unit output is distorted or blown. See
your authorized Infinity car audio dealer.
• PROBLEM:
No output from BassLink when head-unit
fader control set to front or rear (in a 4-channel
connection).
CAUSE and SOLUTION:
Input connections are improperly wired. Verify
all connections (see Applications starting on
page 3).
• PROBLEM:
BassLink turns on before head unit is completely
on and produces a "thump" sound.
CAUSE and SOLUTION:
For speaker-level connections, head unit is
producing a false turn-on signal. On BassLink's
side panel, slide AUTO TURN-ON to OFF.
• PROBLEM:
BassLink's POWER LED remains on after head
unit is turned off.
CAUSE and SOLUTION:
For speaker-level connections, this is normal
operation when AUTO TURN-ON is set to ON.
BassLink will remain on another 5 to 10 minutes
after sensing that audio signals are not present
before shutting down. If you prefer immediate
shut-down, set AUTO TURN-OFF to OFF .
S
PECIFICATIONS
Amplifier Power: 200 W
rms
Frequency Response: 20Hz to 120Hz
Fuse: 20A
Max. Current Draw: 12A
Idle Current Draw: < 800mA
Input Sensitivity: 50mV to 4V
Line-Level Input
1V to 16V
Universal Interface
Crossover Frequency: 50Hz to 120Hz
Crossover Slope: 12dB per octave
Bass Boost: –6dB to +3dB @ 40Hz
Dimensions (L x W x H): 14-1/2" x 12-1/2" x 8-1/2"
(369mm x 318mm x
216mm)
Declaration of Conformity
We, Harman Consumer International
2, route de Tours
72500 Chateau-du-Loir
FRANCE
declare in own responsibility, that the product described in this
owner's manual is in compliance with technical standards:
EN 55013/A12/8.1994
EN 55020/12.1994
Lutz Uphoff
Harman Consumer International
Chateau-du-Loir, France. 4/00
7