Briggs & Stratton 19E400 Operating & Maintenance Instructions page 13

Table of Contents

Advertisement

ENGINE AND ENGINE PARTS
We recommend that you see an authorized Briggs & Stratton Service Dealer for all maintenance and service of the engine
and engine parts. Use only genuine Briggs & Stratton parts.
WARNING
WARNING
MUFFLER
WARNING
move screen for inspection. Replace screen if damaged or
plugged.
SPARK PLUG
Use only Briggs & Stratton Spark Tester (part number
19368) to check for spark.
Note: In some areas, local
law requires using resistor
spark plug to suppress
ignition signals. If this en-
gine
was
originally
equipped
with
resistor
spark plug, use same type
for replacement.
CLEANING DEBRIS
CAUTION: Do not use water to clean engine parts.
Water could contaminate fuel system. Use a brush
or dry cloth.
Daily or before every use, clean
accumulated debris from engine.
Keep linkage, spring and controls
clean. Keep area around and
behind muffler free of any com-
bustible debris.
If you perform any maintenance on the engine, first disconnect the spark plug wire
from the spark plug, and disconnect the battery at the negative terminal (electric
starter engines only) to prevent unintentional sparking. Unintentional sparking can
result in fire or electric shock. Unintentional start-up can result in entanglement,
traumatic amputation or laceration. Use only correct tools.
• Do not strike the flywheel with a hammer or hard object because the flywheel may
later shatter during operation.
• Do not tamper with governor spring, links or other parts to increase engine speed.
Replacement parts for the
muffler must be the same and
installed in the same position
as the original parts, other-
wise fire can occur.
If muffler is equipped with
spark arrestor screen, re-
.030" (0.76 mm)
WIRE GAGE
RESISTOR P/N 802592
STANDARD P/N 492167
Finger Guard
Note: On Model Series 19E400, 19F400, 19G400 engines
use only spark plug, Part No. 496018.
AIR COOLING SYSTEM
We recommend
cleaning the air
cooling
system
every 100 hours.
COMBUSTION DEPOSITS
We recommend that after every 100-300 hours you have
an authorized Briggs & Stratton Service Dealer remove
combustion deposits from the cylinder, cylinder head, top
of piston, and around valves.
WARNING
CLEAN
Linkage, Springs, Controls
13
MAINTENANCE
Engine parts should be kept
clean to reduce the risk of
overheating and ignition of
accumulated debris.
CLEAN
SPARK
ARRESTER
Muffler, Spark Arrester
CLEAN
OUT
DEBRIS
AND
CHAFF
CLEAN

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

19640019f40019740019g400250400192400 ... Show all

Table of Contents