Advertisement
Wall Plate (1 pc.), Mounting Rails (2 pcs.)
Hardware Kits:
Mount Hardware
Qty
Description
4
#12 Phillips Screw
4
Round Washer
4
Wall Anchor
4
Square Washer
1
Hex Wrench
1
Push Pin
2
Display Hardware
ID
Qty
Description
A
4
Philips Screws M4 x 16mm
B
4
Philips Screws M4 x 36mm
C
4
Philips Screws M4 x 45mm
D
4
Philips Screws M5 x 16mm
E
4
Philips Screws M5 x 36mm
F
4
Philips Screws M5 x 46mm
G
4
Philips Screws M6 x 16mm
H
4
Philips Screws M6 x 36mm
I
4
Philips Screws M6 x 46mm
M
4
3/4" Round Spacer
N
2
Round Washer
Step 5: Lock the Display
Engage the lock by sliding the locking tab up into
place. (Fig. 9)
Fig. 9
Make sure that the locking screw is centered in the
lock hole, and then tighten securely with the sup-
plied Hex
Wrench. (Fig. 10)
This will prevent the display from being easily re-
moved or dislodged from the wall mount.
Step 6: Tilt the Display
Fig. 11
7
Fig. 10
To adjust the tilt angle, grasp the top of the
display, and push or pull it into position as
required. If necessary, loosen both tilt ten-
sioning screws just enough so that the dis-
play can be moved by applying pressure to
the upper edge.
To lock in the tilt angle, re-tighten both tilt
tensioning screws. (Fig. 11)
Important: Always support the upper edge
of the display when adjusting the tilt angle.
Advertisement
