Hi Power Operation; Timer Operation; Mode Hi Power; Mode Minuterie - Toshiba RAS-07UKHP-E Owner's Manual

Hi POWER OPERATION

High power (Hi POWER)
• The Hi POWER (high power operation) mode automatically controls room
temperature, air flow and operation mode so that the room is quickly
cooled in summer and warmed in winter. (
Setting Hi POWER mode
1 1
1 Hi POWER button 1 1
Press the Hi POWER button. The Hi POWER lamp (green) on the display
panel of the indoor unit lights up. At the same time, the "Hi POWER" mark
on the remote control is indicated.
Canceling Hi POWER mode
1 1
1 1 Hi POWER button 1
Press the Hi POWER button once again.
The Hi POWER lamp on the display panel of the indoor unit lights goes out.
At the same time, the "Hi POWER" mark on the remote control goes out.
CAUTION
The Hi POWER mode cannot be activated in the DRY and FAN ONLY
operation and when the ON TIMER operation is reserved.

TIMER OPERATION

ON timer and OFF timer
Setting TIMER
1 1 1 ON/OFF TIMER button
1 1
Press the ON or OFF TIMER buttons as required.
• The previous timer setting is displayed and flashes along
with ON/OFF TIMER display.
2 2
2 2 TIMER 2
button
Press the TIMER
Set the timer to the desired time.
Each press of the TIMER button changes the time in ten minute steps.
Pressing the TIMER button continually changes the time in one hour steps.
3 3 3 3 3 SET
button
SET
Press the SET
SET
The timer time is indicated and the timer starts.
4 4 4 CLR
4 4
button
CLR
Press the CLR
CLR
CAUTION
• When you select the timer operation, the remote control
automatically transmits the timer signal to the indoor unit at the
specified time. Therefore, keep the remote control in a location
where it can transmit the signal to the indoor unit properly.
• If you do not press the SET
setting the time, the setting will be cancelled.
Once you select the timer operation mode, the settings are saved in the remote control.
Thereafter, the air conditioner will start operating under the same conditions when you simply press the ON/OFF
button of the remote control.
If the clock display is flashing, you cannot set the timer.
Follow the instructions in the section "SETTING THE CLOCK" on page 6 to set the clock, and then set the timer.
button.
button to set the timer.
button to cancel the timer setting.
button within 30 seconds after
SET
see page 15.)
10
A
START/STOP
FAN MODE
SWING ECO
1 1
TIMER
FIX
ON OFF
FILTER
START/STOP
FAN MODE
SWING ECO
1 1
TIMER
FIX
ON OFF
2 2
FILTER
3 3
4 4
PRESET
AUTO
Hi-POWER
MEMO
SET CLR
RESET CLOCK CHECK
PRESET
AUTO
Hi-POWER
MEMO
SET CLR
RESET CLOCK CHECK
EN