Mazda 3 Smart Start Manual page 39

DASHBOARD ILLUMINATION/
DIMMER
Low Engine Oil Pressure
Power Steering Malfunction
Automatic Transaxle
Warning Light
Charging System
Malfunction
Door/Trunk/Tailgate Ajar
Low Washer Fluid Level
Warning Light
KEY Warning Light
KEY Indicator Light
Check Fuel Cap
Perform Maintenance
• Rotate the knob to adjust the brightness
1
of the instrument cluster and other
dashboard illuminations.
• Push to toggle between trip meter (A & B).
2
• When a trip meter is selected, push and
hold to reset to zero.
1669736_15_Mazda3_SSG_041514.indd 38
/
TRIP METER
1 2
ENGINE COOLANT TEMP LIGHTS
Since this vehicle does not use an engine coolant
temperature gauge, red and blue engine coolant
temperature lights are used to indicate high and
low coolant temperature.
RED
GREEN
NOTE:
dimmer when the headlights are on. If the
illumination is too dim or too bright with the
headlights on, simply rotate the knob to adjust
the brightness of the illumination.
www.MazdaUSA.com
TRIP COMPUTER
The following information can
be selected by pushing the
or of the INFO button on the
steering wheel.
• Approximate distance you
can travel on the available
fuel (RANGE)
• Average fuel economy
• Current fuel economy
• Average vehicle speed
• To reset, push and hold
the INFO button for more
than 1.5 seconds.
Red Coolant Temp Light
Flashing: Engine is starting to run hot.
Drive slowly to reduce engine load.
On: Engine is overheating. Safely pull over
to the side of the road and turn the engine
off. Refer to the Owner's Manual for more
information.
Blue Coolant Temp Light
On: Engine coolant is cold and no warm air
is available for heater/defroster.
Off: Engine coolant is warm and warm air is
available for heater/defroster. The light may
stay on for a few minutes after start-up when
the engine is cold, but the vehicle can be
driven with the light on or off.
The instrument cluster becomes
38
4/15/14 2:17 PM