Pre-Diagnosis Inspection (An400A/Zak9) - Suzuki AN400 Supplementary Service Manual

4E-14 ABS:

Pre-diagnosis Inspection (AN400A/ZAK9)

The mechanical and hydraulic components of the brake
system should be inspected prior to performing any
electrical checks. These inspections may find problems
that the ABS could not detect; thus, shortening repair
time.
Brake
Brake fluid level check
Refer to "Brake System Inspection" in Section 0B in
related manual.
Brake pad inspection
Refer to "Brake System Inspection" in Section 0B in
related manual.
Brake fluid circuit air bleeding
Refer to "Air Bleeding from Brake Fluid Circuit" in
Section 4A in related manual.
Tire
Tire type
Tire type
Front: BRIDGESTONE HOOP B03 G
Rear: BRIDGESTONE HOOP B02 G
Tire pressure
Refer to "Tire Inspection" in Section 0B in related
manual.
CAUTION
!
• The standard tire fitted on this motorcycle
is 120/80-14M/C 58S for front and 150/70-
13M/C 64S for rear. The use of tires other
than those specified may cause instability.
It is highly recommended to use a SUZUKI
Genuine Tire.
• Replace the tire as a set, otherwise the
DTC "25" (C1625) may be stored.
Wheel
B905H14504019
Refer to "Front Wheel Related Parts Inspection" in
Section 2D in related manual and "Rear Wheel Related
Parts Inspection" in Section 2D in related manual.
Battery
Battery voltage inspection
1) Turn the ignition switch OFF.
2) Open the front box and remove the battery cover.
Refer to "Battery Removal and Installation" in
Section 1J in related manual.
3) Measure the voltage between the (+) and (–) battery
terminals using the multi circuit tester.
If the voltage is less than 12.0 V, charge or replace
the battery and inspect the charging system. Refer to
"Battery Runs Down Quickly" in Section 1J in related
manual.
Special tool
Tester knob indication
Voltage (
Battery voltage
12.0 V and more
4) Reinstall the battery cover and close the front box.
(A): 09900–25008 (Multi circuit tester set)
)
( )
(A)
(–)
I905H1450012-01