Janome 6260QC Instruction Manual page 29

Janome 6260QC Instruction Manual
4
8
9
6
7
5
Step 1, 2
Step 3
Step 4
[ 1 ]
[ 2 ]
www.aaasewing.com
10
12
11
13
14
15
4 Raise the buttonhole foot and draw the needle thread
to the left through the hole on the foot. Place the fabric
under the foot and lower the needle at the starting
point by turning the handwheel. Then lower the foot.
Needle thread
6
Bobbin thread
7
Buttonhole mark
8
9 Starting point
NOTE: Make sure there is no gap between the slider and
spring holder, otherwise the left and right length
of the buttonhole will be different.
10
Slider
Spring holder
11
No gap
12
Sewing gap
13
5 Depress the foot control to sew a buttonhole.
The machine will sew a buttonhole in the following order:
Step 1 and 2: Front bartack and left row.
Step 3: Right row.
Step 4: Back bartack and locking stitches at the end
LED shows each sewing step and a dot will
blink when the buttonhole is finished.
End point
14
15 Dot
NOTES: You can sew another layer of the buttonhole
over the previous stitching (see page 28). If
you want to select other pattern or buttonhole,
raise the presser foot then select the desired
pattern.
[1] If you start buttonhole sewing without lowering the
buttonhole lever, the LED display shows ÒbLÓ.
Lower the buttonhole lever and restart the machine.
[2] If you select the other pattern without raising the
presser foot or buttonhole lever, the LED display
shows ÒUPÓ. Select the other pattern after raising the
foot and buttonhole lever.
6260QC Owners Manual/ User Guide
Janomesewing machine
27