Mounting On A Table; Tidying Cables - LG 47LS460055LS4600 Owner's Manual

Mounting on a table

1
Lift and tilt the TV into its upright position on a
table.
- Leave a 10 cm (4 inches) (minimum) space
from the wall for proper ventilation.
10 cm
2
Connect the power cord to a wall outlet.
CAUTION
Do not place the TV near or on sources
y y
of heat, as this may result in fire or other
damage.
Securing the TV to a table
(For 47LS4600, 32/37/42/47LS5600, 42/47LS5650)
Fix the TV to a table to prevent from tilting
forward, damage, and potential injury.
To secure the TV to a table, insert and tighten the
supplied screw on the rear of the stand.
WARNING
To prevent TV from falling over, the TV
y y
should be securely attached to the floor/wall
per installation instructions. Tipping, shaking,
or rocking the TV may cause injury.
10 cm
(4 inches)
1 0 c m
10 cm
ASSEMBLING AND PREPARING
Adjusting the angle of the TV to suit view
Swivel 20±2 degrees to the left or right and adjust
the angle of the TV to suit your view.
20 2
CAUTION
When adjusting the angle of the TV,
y y
watch out for your fingers.
- Personal injury may occur if hands or
fingers are pinched. If the product is
tilted too much, it may fall, causing
damage or injury.

Tidying cables

1
Gather and bind the cables with the cable
holder.
CAUTION
Do not move the TV by holding the cable
y y
holder, as the cable holders may break, and
injuries and damage to the TV may occur.
13
20 2
Cable holder