Table of Contents
Advertisement
12. Slide the server into the rack enclosure until it stops; then, secure the server in
13. Connect all external cables and turn on the server.
Note: Use the Configuration/Setup Utility program to configure the serial port.
Installing or replacing a drive
This section provides the instructions for installing and replacing a hot-swap hard
disk drive, diskette drive, and DVD-ROM drive.
Hot-swap hard disk drive
Attention:
damage from static electricity. For details on handling these devices, see "Handling
static-sensitive devices" on page 80.
The following steps describe how to install or replace a hot-swap hard disk drive.
Note: Hard disk drives can only be hot-swapped if hard drive mirroring, such as
1. Inspect the drive for any signs of damage.
2. Review the information in "Installation guidelines" on page 79 and "Safety
3. Check the instructions that come with the drive for more information about
4. Remove the filler panel or defective hard disk drive from the hard disk drive bay.
5. Install the new hard disk drive in the drive bay:
Figure 42. Installing a hard disk drive
94
xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide
the rack enclosure using the quick release latches.
When you handle static-sensitive devices, take precautions to avoid
that available with RAID, is in effect.
information" on page 257.
installing your drive.
a. Ensure that the handle on the hard disk drive tray is in the open position.
b. Slide the drive into the bay until it stops.
c. Push the handle on the front of the hard disk drive closed.
Filler panel
Advertisement
Table of Contents
Troubleshooting
