Contents Of Shipping Container; Unpacking And Clean-Up - Jet JMD-15 Operating Instructions And Parts Manual

5.0 Contents of Shipping
Container
1 Mill/Drill Machine
Accessory Package:
1 1/2" Drill Chuck w/ Chuck Key
1 Adjustable Carbide Facemill
1 Facemill Arbor
1 Bolts, Nuts, and Washers to
Attach Vise to Table
1 2-1/2" Angle Vise (JMD-15)
1 3" Angle Vise (JMD-18/18PFN)
3 Handle Rods (JMD-15/18)
3 Rubber Knobs (JMD-15/18)
2 Rubber Knobs (JMD-18PFN)
1 3/8"x1" Hex Socket Cap Screw
1 3/8" Washer
1 Crank Body (Installed)
1 Crank Handle
1 Spindle Guard Assembly
1 3mm Hex Wrench
1 4mm Hex Wrench
1 5mm Hex Wrench
1 23mm Wrench (JMD-18/18PFN)
3 Hand Wheels w/ Handles
1 Can Touch-Up Paint
1 Owner's Manual
1 Warranty Card
1 Lifting Hook (Installed)

6.0 Unpacking and Clean-up

1. Finish removing the crate from the mill/drill.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
2. Clean all rust protected surfaces using a
mild commercial solvent, kerosene or diesel
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE® Oil Heavy Medium.
3. Open the belt cover and thread the lifting
hook into the head.
4. Carefully lift the mill/drill with properly rated
equipment to a sturdy stand or work bench.
5. Remove the lifting hook.
Tools Needed for Assembly
8" Adjustable Wrench or 1/4" to 1-1/4"
Combination Wrench Set
(JMD-18 shown with optional CS-18 stand)
6