Table of Contents
Advertisement
18
AIR FILTER
Level 1.
Tools required: 25 or 50 mm (1 or 2 in.) cleaning brush
Parts required: 90030 REPOWER
1.
Close choke (Cold Start Position [
entering the carburetor throat when the air filter is removed. Brush
accumulated dirt from the air filter area.
2.
Remove the air filter cover. Lightly brush debris from filter. If filter
is fuel soaked, deformed, or very dirty, replace it.
3.
If filter can be reused, be certain it:
• fits tightly in the air filter cavity.
• is installed with the original side out.
NOTE
Carburetor adjustment may be needed after air filter cleaning or
replacement. See Carburetor Adjustment Section.
FUEL FILTER
Level 1.
Tools required: 200-250 mm (8 - 10 in.) length of wire with one end
bent into a hook, clean rag, funnel, and an approved
fuel container
Parts required: 90030 REPOWER
WARNING
Fuel is VERY flammable. Use extreme care when mixing, storing or
handling.
1.
Use a clean rag to remove loose dirt from around fuel cap and
empty fuel tank.
2.
Use the "fuel line hook" to pull the fuel line and filter from the
tank.
3.
Remove the filter from the line and install the new filter.
TM
Air & Fuel Filter Kit
]). This prevents dirt from
TM
Air & Fuel Filter Kit
DANGER
Advertisement
Table of Contents
