Auto Restart; Temperature And Humidity Range - Fujitsu AWT14RB Operating Manual

Ceiling wall type room air conditioner
Table of Contents

Advertisement

OPERATING TIPS
Instructions relating to heating (*) are applicable only to "HEAT & COOL MODEL" (Reverse Cycle).

AUTO Restart

In Event of Power Interruption
G Should the power supply to the air conditioner be inter-
rupted by a power failure, the air conditioner will restart
automatically in the previously selected mode once the
power is restored.
G Should a power failure occur during TIMER operation,
the timer will be reset and the unit will begin (or stop)
operating under the new timer setting. In this event, the
TIMER indicator lamp (yellow) will flash (see page 4).

Temperature and Humidity Range

COOLING/DRY MODE
COOLING MODELS
HEAT & COOL
MODELS
(Reverse Cycle)
*HEATING MODE
HEAT & COOL
MODELS
(Reverse Cycle)
G If the air conditioner is used under higher temperature conditioner than those listed, the built-in protection circuit may
operate to prevent internal circuit damage. Also, during Cooling and Dry modes, if the unit is used under conditions of
lower temperature than those listed above, the heat-exchanger may freeze, leading to water leakage and other damage.
G Do not use this unit for any purposes other than the Cooling, (*)Heating, Dehumidifying, and air-circulation of rooms in
ordinary dwellings.
15
Outdoor
Outdoor
Unit
Temperature
AOT18A
About 21 to 43 °C
AOT24A
About 0 to 43 °C
AOT30A
About 21 to 43 °C
AOT14R
AOT18R
About 0 to 43 °C
AOT24R
AOT30R
Outdoor
Outdoor
Unit
Temperature
AOT14R
About 0 to 24 °C
AOT18R
AOT24R
About – 5 to 24 °C
AOT30R
G Use of other electrical appliances (electric shaver, etc.) or
nearby use of a wireless radio transmitter may cause the
air conditioner to malfunction. In this event, temporarily
disconnect the power supply, reconnect it, and then use
the remote control unit to resume operation.
Temperature
About 18 to 32 °C
Indoor
Temperature
About 30 °C or less
Indoor
Humidity
About 80 % or less
If the unit is used for long pe-
riods under high-humidity
conditions, condensation
may form on the surface of
the indoor unit, and drip onto
the floor or other objects un-
derneath.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents