Table of Contents
Advertisement
KRC-4902Y
QQ
3 7 63 1515 0
TEST MODE
1. How to enter the test mode
• Reset the unit while holding the "FM" key and preset "6"
key.
• All indication segments go ON at the beginning of the test
mode.
2. How to release the test mode
• Simply reset the unit.
• (NOTE) The test mode should not released in conditions of
ACC OFF, power OFF, momentary power down or the
panel off.
3. Test mode
• Blanking Skip (B.S) OFF.
• Eject a tape by pressing "ATT" key.
ADJUSTMENT
BALANCE/FADER/BASS/TREBLE
T.ADV/METAL/DOLBY NR/AUTO
INPUT
No.
ITEM
SETTINGS
TE
L 13942296513
CASSETTE DECK SECTION
TCC-153
1
AZIMUTH
10kHz
www
.
6
TEST MODE / ADJUSTMENT
: CENTER
: OFF
OUTPUT
RECIEVER
SETTINGS
SETTINGS
SP OUT
TAPE PLAY
(b) AZIMUTH
x
ao
u163
y
i
2 9
8
4. Audio adjustment
• Enter the audio mode by pressing the "AUD" key or
"OPEN/CLOSE" key on the remote controller.
• Set the volume level to be -10dB. In that case, "30" should
be shown on the display.
• Loudness OFF.
• The BASS/MIDDLE/TREBLE and BALANCE/FADER can
be adjusted to the full-boost/full-cut and full-front/ full-rear
each by pressing the "UP" and "DOWN" keys.
5. Menu mode
• Enter the menu mode by pressing "CLK" key or "DNPP"
key on the remote controller.
• Only on models with RDS function, Local Seeking should
be first menu.
ALIGNMENT
POINTS
Q Q
3
6 7
1 3
Head azimuth
Adjust so that output level in
screw
playing "FWD"and "REV"
(FWD/REV)
becomes maximum each.
(ME1)
FWD
REV
.
9 4
2 8
ALIGN FOR
1 5
0 5
8
2 9
9 4
m
co
PANEL FRONT
9 9
FIG.
2 8
9 9
(b)
Advertisement
Table of Contents
