Pioneer VSX-1015-S Service Manual page 135

5
Display
1 2
17
1 Speaker indicators
Lights to indicate the current speaker system, A and/or B.
2 SIGNAL SELECT indicators
Lights to indicate the type of input signal assigned for the
current component:
AUTO
Lights when AUTO signal select is on.
DIGITAL
Lights when a digital audio signal is detected.
ANALOG
Lights when an analog signal is detected.
3 Digital format indicators
DIGITAL
Lights when a Dolby Digital encoded signal is detected.
DTS
Lights when a DTS encoded signal is detected.
WMA9 Pro
Lights to indicate decoding of a WMA9 Pro signal.
4 Program format indicators
These change according to which channels are active in Dolby
and DTS encoded sources. LS, S and RS will light at the same
time to indicate 6.1channel sources.
• L – Left front channel
• C – Center channel
• R – Right front channel
• LS – Left surround channel
• S – Surround channel (mono) or surround back channel
• RS – Right surround channel
• LFE – Low frequency effects channel
5 Matrix decoding format indicators
PLII
This lights to indicate Pro Logic II / Pro Logic IIx decoding.
Neo:6
When one of the Neo:6 modes of the receiver is on,
this lights to indicate Neo:6 processing.
6 Listening mode indicators
THX
Lights when one of the Home THX modes is selected.
VIR.SB
Lights during Virtual surround back processing.
ADV.SURR
Lights when one of the Advanced Surround modes has
been selected.
5
6
3 4
16 6 15
VSX-1015-K
6
7
5 6 7
14 13
AUTO SURR
Lights when the Auto Surround feature is switched on.
7 MIDNIGHT / LOUDNESS
When Midnight or Loudness listening is switched on, the
corresponding indicator shows in the display.
8 Input source indicators
Light to indicate the input source you have selected.
9 ATT
Lights when INPUT ATT is used to attenuate (reduce) the level
of the analog input signal.
10 OVER
Lights to indicate that the level of an analog source is too high.
Use the attenuator (INPUT ATT) to reduce it.
11 Master volume level
Shows the overall volume level. –80dB indicates the
minimum level, and +12dB indicates the maximum level.
12 EON / RDS indicators
EON
EON lights when the EON mode is set, and flashes
during reception of an EON broadcast. The
lights when the current station carries the EON service.
RDS
Lights when an RDS broadcast is received.
13 DE
Lights when Dialog Enhancement (DIALOG E) is switched on.
14 TUNER indicators
STEREO
Lights when a stereo FM broadcast is being received in
auto stereo mode.
MONO
Lights when the mono mode is set using the MPX button.
TUNED
Lights when a broadcast is being received.
15 Character display
Displays various system information (for example, the reason
an operation is not possible may flash in the display).
16 SR+
Lights when the SR+ control mode has been switched on.
17 SLEEP
Lights when the receiver is in sleep mode.
7
8
8 9
12 11 10
indicator
8
A
B
C
D
E
F
135