Port Configuration - Encore SP201-SA Installation Manual

4
B Port Configuration
What the terminal displays
user>
List of Valid LIMs
1) 1 E1 120 Ohm/1 E1 120 Ohm
2) 2 T1 100 Ohm/1 E1 120 Ohm
3) 1 T1 100 Ohm/1 T1 100 Ohm
4) 2 T1 100 Ohm/2 T1 100 Ohm
5) 1 E1 120 Ohm/1 T1 100 Ohm
6) 1 E1 120 Ohm/2 T1 100 Ohm
7) 1 T1 100 Ohm/1 E1
8) 1 T1 100 Ohm/1 E1 120 Ohm
9) 1 E1 75 Ohm/1 T1 100 Ohm
10) 1 E1 75 Ohm/1 E1
> 11) 1 E1 75 Ohm/1 E1 120 Ohm <
12) 1 E1 120 Ohm/1 E1
13) 2 T1 100 Ohm/2 E1
14) 2 T1 100 Ohm/2 E1 120 Ohm
15) 2 E1 75 Ohm/2 T1 100 Ohm
16) 2 E1 75 Ohm/2 E1
17) 2 E1 75 Ohm/2 E1 120 Ohm
18) 2 E1 120 Ohm/2 T1 100 Ohm
19) 2 E1 120 Ohm/2 E1
20) 2 E1 120 Ohm/2 E1 120 Ohm
Enter LIM Choice from list above
[1-20] (current=11) ==>
Select the configuration that supports your SP201-SA's port connections,
and press the Enter key. (The
SP201-SA.)
Note: The standard choices shown below, in boldfaced numbers, include
120-ohm E1 interfaces. E1 interfaces may instead use 75 ohms over a BNC
connector. If you use BNC connectors, choose an appropriate combination
from the List of Valid LIMs
Protocol Conversion
DTMF–ETSI ISDN
DTMF–NI2 ISDN
R1–NI2 ISDN
R2–ETSI ISDN
R2–NI2 ISDN
(A message similar to the following appears only if you
change the LIM configuration.)
LIM set to: 2 E1 120 Ohm/2 E1 120 Ohm
A coldstart is required for this
change to take effect
Do you wish to reset now (y/n)?
What you type
config lim
75 Ohm
75 Ohm
75 Ohm
75 Ohm
75 Ohm
75 Ohm
List of Valid LIMs shown is for a four-port
above.
Interfaces 2-Port
T1/E1
T1/T1
T1/T1
E1/E1
E1/T1
y
now, so that
subsequent
configuration
parameters will
reflect the
SP201-SA's port
configuration.)
SP201-SA™ Installation Guide
What you are configuring
Interfaces for the
SP201-SA's ports
4-Port
8 14
3 4
3 4
1 20
Ports 1 and 2/Ports 3 and 4
5 18
(You must do this
Implementation of port
configuration