Install Stator Assembly; Install Starter Adapter; Install Flywheel - Kohler AEGIS LH630 Service Manual

3. Connect the wire leads to the temperature warning
switch, audible alarm, and/or Oil Sentry™ switch,
as equipped.

Install Stator Assembly

1. Place a small amount of pipe sealant with
® ®
Teflon (Loctite 59241 or equivalent) into the
holes for the two stator mounting screws. Position
the stator assembly onto the mounting studs so
the leads are at the bottom, and directed out
toward the #1 side, in the 3 o'clock position. Align
the mounting holes and install the two hex. flange
screws. Torque each screw to 6.2 N·m (55 in. lb.).
See Figure 11-63.
Figure 11-63. Torquing Stator Screws.

Install Starter Adapter

1. Install the starter adapter to the crankcase, so the
cutout is offset down and facing away from the
flywheel side. Install the two mounting screws, and
position the clamp for the stator leads on the upper
screw. See Figure 11-64. Torque the screws to
15.3 N·m (135 in. lb.).
Figure 11-64. Installing Starter Adapter.
www.SmallEngineDiscount.com
2. Place the stator leads within the clamp and close
the loop. See Figure 11-65.
Figure 11-65. Routing Stator Leads through Clamp
on Adapter.
3. If the violet B+ charge lead is separate from the
main harness, secure it to the wiring harness with
a tie strap, directly above the clamp. See Figure
11-66.
Figure 11-66. Side View of Stator and B+ Leads
Tied to Clamp on Adapter.

Install Flywheel

Flywheel Can Cause Personal Injury!
Using improper procedures to install the flywheel can
crack or damage the crankshaft and/or flywheel. This
not only causes extensive engine damage, but can also
cause personal injury, since broken fragments could be
thrown from the engine. Always observe and use the
following precautions and procedures when installing
the flywheel.
Not For Resale
WARNING: Damaging Crankshaft and
Section 11
Reassembly
11
11.19