Step 10 - Final Preparation; Routine Maintenance - Friedrich Breeze BRO412W1A Installation Instructions Manual

STEP 10 – Final Preparation.
Using the supplied connecting line clips, secure the connecting line to the interior and exterior walls as desired. 5
retaining clips are provided from the factory.
Once the connecting line is secure and Steps 1-8 are complete, you may plug in the Breeze system and enjoy your
new air conditioner.
For installations with the connecting line going through the wall (option 1) use the supplied filler gasket to plug
the hole around the connecting line in the wall opening. Additional sealing may be desired or necessary for proper
weatherproofing.

Routine Maintenance

Cleaning the unit:
The outer cover of the Breeze indoor module can be cleaned with a
damp cloth.
Cleaning the outdoor module can be done by rinsing the module with
low pressure water. Refer to friedrich.com for approved coil cleaning
agents.
Cleaning the filter:
The indoor module of the Breeze system has a washable filter that
should be inspected and cleaned periodically. To access and clean
the filter follow these steps.
Open the front panel by pulling on the left and right side tabs. The
front panel will open upward and lock into the open position.
Remove the left and right air filters from the Breeze module.
Wash the filters by rinsing with water or by vacuuming the dirt from
the filter. Allow the filter to dry completely prior to reinstalling.
Reinsert both air filters. Then, lower the front panel and snap the
panel into place.