Ariens Pro 28 Quick Start Manual page 6

Install Discharge Chute Rod Cont.
IMPORTANT: The hook will prevent the control cable from contacting
the engine or muffler guard.
NOTE: After the chute rod has been inserted through the hex hole in
the control assembly, placing the unit in the service position (see
Service Position in Owners Manual) will ease alignment and installation
of the hairpin.
4. Secure the chute rod to the control assembly with the hairpin
removed in step above using the end hole location. Insert the
hairpin with the loop end to the left of the chute rod so the control
assembly follows a full range of travel.
5. Replace the gear cover removed above.
6. Orient the chute and pedestal to its most vertical position and
tighten pedestal hardware to 15 – 31 lbf-ft (20 – 42 N•m).
7. Make sure the discharge chute rotates left and right when you
push the discharge chute control lever left and right.
NOTE: If chute does not stay in position, adjust as directed in
Discharge Chute in Owners Manual, or repair before operation.
Step Four: