D-Link DAP-1520 User Manual page 59

Section 6 - Troubleshooting
• To access the web management interface, open your web browser and enter http://dlinkap.local./.or.http://192.168.0.50*.
in the address bar. This should open the login page for the web-based configuration utility.
*Note: This is the default IP address. Once the DAP-1520 connects to your router, it will be assigned a new IP address based on your
router/network's DHCP settings. You will have to log in to your router and view the DHCP table to see what IP address was assigned
to the DAP-1520. If you are using a D-Link router, follow these instructions to find the IP address that was assigned:
Using the router's Web-based configuration utility, go to Setup > Network Settings. Scroll down to the bottom of the page, below
the heading that says Number of Dynamic DHCP Clients, to view the list of connected devices. Refer to the MAC address that is
printed on the label that is attached to the bottom of the DAP-1520 to find the corresponding IP address.
• If you still cannot access the configuration, unplug the extender from the power outlet for at least 10 seconds and plug it
back in. Wait about 30 seconds and try accessing the configuration. If you have multiple computers, try connecting using a
different computer.
2..What.can.I.do.if.I.forgot.my.password?
If you forgot your password, you must reset your extender. Unfortunately this process will change all your settings back to
the factory default settings.
To reset the extender, locate the reset button (hole) on the side of the unit. With the extender
powered on, use an unfolded paper clip to hold the button down for 10 seconds. Release the
button and the extender will go through its reboot process (as indicated when the LED turns
solid red).
Wait for at least 30 seconds to access the extender. The default IP address is
http://dlinkap.local./. When logging in, the username is admin and leave the password field
empty.
D-Link DAP-1520 User Manual
Reset
55