Kenwood XD-A75 XD-A55 Instruction Manual page 14

To interrupt playback :
1 Press the 8 button on the remote control.
• "8" will light up.
2 Press the 3 button to resume playback from the
same point.
To stop playback :
Press the 7 STOP button.
To remove the CDs :
Whilst in the stop mode, press the 0 OPEN/CLOSE
button.
•
The disc tray will open. Remove the two discs.
Then, press the DISC SKIP button to rotate the
disc tray and remove the remaining disc.
After use :
Press the POWER / ON/STANDBY button to enter
the standby mode.
2
DISC 1 - DISC 3
14
EN
Disc number selection
1
1
2
•
Notes :
• When the DISC SKIP button is pressed during
• When one of the disc number buttons (DISC 1-
1
2
Cautions :
•
Do not carry the unit with discs left in the disc
trays. The disc may become loose inside the
unit and they may be damaged or cause dam-
age to the unit. This may also cause malfunc-
tions.
•
Do not place two CDs in one disc position.
•
Do not push the disc tray whilst it is moving.
•
Do not attempt to turn the disc tray by hand.
This may cause malfunctions.
•
If the power fails whilst the tray is open, wait
until the power is restored.
•
If the disc tray is stopped forcibly, "ERR" will
appear in the display and the unit will not func-
tion.
If this occurs, press the POWER / ON/STANBY
button to enter the standby mode and then turn
the power on again.
•
If TV or radio interference occurs during CD
operation, move the unit away from the TV or
radio.
•
If a disc is damaged, dirt, or loaded upside
down, the disc will be skipped and the next
disc will automatically play.
When stopped, press the DISC SKIP button.
Press the 3 button.
The next disc playback will begin, after which
each following disc will be played sequentially.
playback, playback will begin automatically from
the next disc. (It is not necessary to press the 3
button.)
DISC 3) is pressed during playback, playback of
the selected disc will begin automatically. (It is
not necessary to press the 3 button.)