Major Components - Graco 223-773 A Series Instructions And Parts List

S
K
M
Fig. 1
A Motor (Under shield shown)
B Pressure Adjusting Knob
C ON/OFF Switch, Circuit Breaker
D Drive Assembly
E Fluid Filter
F Secondary Fluid Outlet
G Pail Hanger
H Displacement Pump
J 50 ft (15 m) Main Hose
K RAC IV Tip Guard
L Contractor Gun
M RAC IV Switch Tip
N 3 ft (0.9 m) Hose
P Pressure Drain Valve
R Pressure Control
S Spray Gun Safety Latch
T Primary Fluid Outlet
U 15/20 Amp Switch

Major Components

C
D
E
F
G
H
J
DC motor, 120 Vac, 18A, 1 phase
Controls fluid outlet pressure
Power switch that controls 120 Vac power to sprayer; with circuit
breaker
Transfers power from DC motor to the displacement pump
Filter of fluid between source and spray gun
Second hose and spray gun is connected here
Container of fluid to be sprayed may be hung here
Pressures fluid to be sprayed through spray gun
1/4 in. ID, grounded, nylon hose with spring guards on both ends
Reverse-A-Clean (RAC) tip guard reduces the risk of fluid injection injury
High pressure spray gun with gun safety latch
RAC switch tip atomizes fluid and removes clogs from spray tip without
removing tip from spray gun
3/16 in. ID, grounded, nylon hose used between 50 ft hose and spray
gun to allow more flexibility when spraying
Relieves fluid pressure when open
Controls motor speed to maintain fluid pressure. Works with pressure
adjusting knob.
Inhibits accidental triggering of spray gun
Hose and spray gun is connected here
Allows sprayer to operate on 15A service with reduced performance
A
B
L T P
R
U
N
01888