Preparing The Remote Control - Kenwood KR-V8090 Instruction Manual

PRE OUT connections
This receiver has additional preout jacks. These can be used for various purposes, but will need to be connected to an external power
amplifier as shown in the example below. Connecting a speaker cord directly to a PRE OUT jack will not produce any sound from the
speaker.
Be sure to set one of the SPEAKERS keys (either A or B) to the ON position when using the PRE OUT jacks.
Surround Power amp
Speakers

Preparing the remote control

Loading the batteries
1 Remove the cover.
1. The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.
2. Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate or if the
Notes Notes
remote control blinks 5 times when you push a key. The remote control is designed to retain set up codes in memory while you change
batteries. Failure to change batteries after receiving the 5 blink battery warning signal may cause all the memory to be lost (KR-V8090 only).
3. Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent malfunction.
Operating distance
This remote control has two IR emitters: one to send commands
in a straight line over long distances, allowing you to control the
receiver and your other components from farther away; and one
for wide dispersion of commands in a closer proximity, for near-
field operation even when the remote control is not pointed
directly at the respective component.
PRE OUT
SURROUND CENTER
SUB
WOOFER
2 Insert the batteries.
• Insert four AAA-size (LR03) batteries as indicated by the polarity markings.
Setting up the system
Power amp
3 Close the cover.
6 m
10 m
30˚ 30˚
KR-V9090: Model: RC-R0805
KR-V8090: Model: RC-R0606
Infrared ray system
KR-V9090/8090 (En/T)
1 3
Center Speaker
Powered
Subwoofer
Remote sensor