Installation Procedure - Kenwood X1200M Instruction Manual

Installation
380 mm
320 mm
ø 6
Hexagon socket
head cap screw
(M4 × 8 mm)
Dressing cover
Self-tapping screw
Cooling fan
(ø5 × 18 mm)
■ Remote controller (Optional accessory)
Mounting bracket
Remote controller
Accessories

Installation procedure

Since there are large variety of settings and connections possible according to
applications, read the instruction manual well to select the proper setting and
connection.
1. Remove the ignition key and disconnect the negative · terminal of the
2. Set the unit according to the intended usage.
3. Remove the Dressing cover.
4. Connect the input and output wires of the units.
5. Connect the speaker wires.
6. Connect the power wire, power control wire and grounding wire following
Hexagon Wrench 7. Install the installation fittings in the unit.
(Small) 8. Attach the unit.
9. Install the remote controller. (Optional accessory)
10. Attach the Dressing cover.
11. Connect the negative · terminal of the battery.
• Do not install in the below locations;
• Do not install the unit under the carpet. Otherwise heat build-up occurs
• Install this unit in a location which allows heat to easily dissipate.
• The surface temperature of the amplifier will become hot during use. Install
• When making a hole under a seat, inside the trunk, or somewhere else in
• Do not install near the dashboard, rear tray, or air bag safety parts.
• The installation to the vehicle should securely fasten the unit to a place in
• After installing the unit, check to make sure that electrical equipment
Installation board, etc.
(thickness : 15 mm or more)
Accessories
Self-tapping screw
(ø2.6 × 12 mm)
Part name
Self-tapping screws
(ø5 × 18 mm)
Hexagon Wrench (Large)
Hexagon Wrench (Small)
Terminal cover (Power terminal)
battery to prevent short circuits.
this order.
CAUTION
(Unstable location, In a location that interferes with driving, In a location
that gets wet, In a dusty location, In a place that gets hot, In a place that
gets direct sunlight, In a location that gets hit by hot air)
and the unit may be damaged.
Once installed, do not place any object on top of the unit.
the amplifier in a place where people, resins, and other substances that are
sensitive to heat will not come into contact with it.
the vehicle, check that there is nothing hazardous on the opposite side
such as a gasoline tank, brake pipe, or wiring harness, and be careful not to
cause scratches or other damage.
which it will not obstruct driving. If the unit comes off due to a shock and
hits a person or safety part, it may cause injury or an accident.
such as the brake lamps, turn signal lamps and windshield wipers operate
normally.
Part name
Remote cable (6.0 m : 19.7 ft)
Remote controller
Mounting bracket
Self-tapping screws
(ø2.6 × 12 mm)
External View Number of Items
4
1
1
1
External View Number of Items
1
1
1
2
English