Kenwood G-EQ300 Instruction Manual page 16

1 6
5
Select the center frequency.
6
Adjust the level.
7
Select the inclination of the curve.
8
When adjustment of center frequencies F2 and/
or F3 is required:
Repeat steps 4 to 7 above for each center frequency.
When two curves F1 and F2 or three curves F1, F2 and F3 are set,
the curve combining them will be displayed in a few seconds.
FREQUENCY JOG
EQ.LEVEL
WIDE/NARROW
Creation of desired equalizer patterns
9 8 H Z
63 98 160
¶Pressing the FLAT key allows to start adjustment from the flat level
position.
Each press switches the display as follows.
1 WIDE
: Curve with a gentle slope.
2 NARROW: Curve with a sharp slope.
63 98 160 250 400 625 1k
WIDE
¶One adjusted, the curve remains the same until next time it is pressed.
40 63 98 160 250 400
40 63 98 160 250 400
¶For finer adjustment, perform the graphic mode operation described
in the following page.
G-EQ300 (En/K)
250 400 625 1k
One the two
shall light up.
WIDE NARROW
63 98 160 250 400 625 1k
NARROW
625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k
625 1k 1.5k 2.5k 3.9k 6.3k 10k 16 k
&