Supero A+ SERVER 4042G-6RF User Manual page 70

A+ SERVER 4042G-6RF/TRF User's Manual
I2C to PCI-Express Slot
JI C1/JI C2 allows you to enable the I
2 2
to communicate with the PCI-Express slot.
For the jumpers to work properly, please set
both jumpers to the same setting. If enabled,
both jumpers must be enabled. If disabled,
both jumpers must be disabled. See the table
on the right for jumper settings.
Watch Dog Enable/Disable
JWD1 enables the Watch Dog function, a
system monitor that takes action when a
software application freezes the system.
Jumping pins 1-2 will have WD reboot the
system if a program freezes. Jumping pins
2-3 will generate a non-maskable interrupt
for the program that has frozen. See the
table on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to enable
or disable the LAN1 and LAN2 Ethernet
ports. See the table on the right for jumper
settings. The default setting is enabled.
SAS Enable/Disable
JPS1 allows you to enable or disable
the SAS controller for the H8QG 6 - F
serverboard only. The default position is on
pins 1 and 2 to enable SAS. See the table
on the right for jumper settings.
VGA Enable/Disable
JPG1 allows you to enable or disable the
VGA port. The default position is on pins 1
and 2 to enable VGA. See the table on the
right for jumper settings.
I C to PCI-Express Slot
2
Jumper Settings
C bus
2
Jumper Setting Definition
Closed
Open
Jumper Settings (JWD1)
Jumper Setting
Pins 1-2
Pins 2-3
Open
Note: When Watch Dog is
enabled, the user must write
their own application software
to disable the Watch Dog
Timer.
LAN1/2 En/Disable
Jumper Settings (JPL1)
Jumper Setting
Pins 1-2
Pins 2-3
SAS Enable/Disable
Jumper Settings (JPS1)
Jumper Setting
Pins 1-2
Pins 2-3
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting
Pins 1-2
Pins 2-3
5-22
(JI C1/JI C2)
2 2
Enabled
Disabled
Watch Dog
Definition
Reset
NMI
Disabled
Definition
Enabled
Disabled
Definition
Enabled
Disabled
Definition
Enabled
Disabled