JVC KD-SX8250 Service Manual page 16

KD-SX8250/KD-SX780
QQ
3 7 63 1515 0
Removing the gears (See Fig.33 to 36)
Prior to performing the following procedure, remove
the top cover, the chassis unit, the top plate
assembly and the pickup unit.
1. Pull out the feed gear.
2. Move the loading plate assembly in the direction of
the arrow to release the slide plate from the two slots
j' of the chassis rivet assembly.
3. Detach the loading plate assembly upward from the
chassis rivet assembly while releasing the joint k'.
Remove the slide hook and the loading plate spring
from the loading plate assembly.
4. Pull out the loading gear (2) and remove the change
lock lever.
5. Remove the E-washer and the washer attaching the
changer gear (2).
6. The changer gear (2), the changer gear spring and
the adjusting washer come off.
7. Remove the loading gear (1).
TE
L 13942296513
8. Move the hang plate rivet assembly in the direction
of the arrow to release from the three shafts of the
chassis rivet assembly upward.
9. Detach the loading gear plate rivet assembly from
the shaft of the chassis rivet assembly upward while
releasing the joint l'.
10. Pull out the loading gear (4).
Loading plate assembly
Loading plate spring
www
Chassis rivet assembly
1-16
http://www.xiaoyu163.com
Joint k'
Slide hook
Slide plate
Slot j'
x ao
y
Slot j'
. i
Fig.35
http://www.xiaoyu163.com
8
Feed gear
Change plate
rivet assembly
Shafts
Q Q
3 6 7 1 3
E-washer
E-washer
Washer
Loading gear (1)
Loading gear (2)
Loading plate spring
Adjusting washer
Change plate
rivet assembly
u163
Chassis rivet assembly
.
2 9 9 4 2 8
Slot j'
Slide plate
Loading plate assembly
Joint k'
Slot j'
Fig.33
Joint l'
Loading gear (4)
Loading gear plate
rivet assembly
1 5 0 5 8 2 9 9 4
Loading gear (2)
Loading gear (1)
Change gear (2)
Fig.34
Loading gear (2)
Change lock lever
Loading gear (4)
m
co
Loading gear plate rivet assembly
Fig.36
9 9
2 8 9 9