Pontiac 2006 G6 Owner's Manual page 102

It is possible for the PASS-Key
the transponder value of a new or replacement key. Up to
10 additional keys may be programmed for the vehicle.
The following procedure is for programming additional
keys only. If all the currently programmed keys are lost
or do not operate, you must see your dealer/retailer or a
locksmith who can service PASS-Key
made and programmed to the system.
See your dealer/retailer or a locksmith who can service
®
PASS-Key III+ to get a new key blank that is cut
exactly as the ignition key that operates the system.
To program the new key:
1. Verify that the new key has
2. Insert the already programmed key in the ignition
and start the engine. If the engine will not start,
see your dealer/retailer for service.
3. After the engine has started, turn the key to
LOCK/OFF, and remove the key.
2-20
®
III+ decoder to "learn"
®
III+ to have keys
1
stamped on it.
4. Insert the key to be programmed and turn it to the
ON/RUN position within five seconds of removing
the original key.
The security light will turn off once the key has
been programmed.
5. Repeat Steps 1 through 4 if additional keys are to
be programmed.
If you are ever driving and the security light comes on
and stays on, you may be able to restart your engine if
you turn it off. Your PASS-Key
is not working properly and must be serviced by your
dealer/retailer. Your vehicle is not protected by the
®
PASS-Key III+ system at this time.
If you lose or damage your PASS-Key
your dealer/retailer or a locksmith who can service
®
PASS-Key III+ to have a new key made.
Do not leave the key or device that disarms or
deactivates the theft deterrent system in the vehicle.
®
III+ system, however,
®
III+ key, see